Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Jeep Commander 2WD V6-3.7LFACTORY OEM SERVICE PROCEDURE
Front Control
INSTALLATION
1. Position the A/C-heater control (4) and the electronic vehicle information center (EVIC) control (3) into the instrument panel center bezel (1).
2. Install the screws (2) that secure the A/C-heater control and the EVIC control to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel onto the instrument panel Instrument Panel Center Bezel - Installation.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool. Refer to HVAC System Test. HVAC System Test
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.