Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Wrangler V6-3.8LFACTORY OEM SERVICE PROCEDURE
Recall 07V291000: TIPM Reprogramming for Engine Stalling
MAKE/MODELS: MODEL/BUILD YEARS:
Dodge/Nitro 2007
Jeep/Wrangler 2007
MANUFACTURER: DaimlerChrysler Corporation
NHTSA CAMPAIGN ID NUMBER: 07V291000 MFR'S REPORT DATE: July 03, 2007
COMPONENT: Electrical System
POTENTIAL NUMBER OF UNITS AFFECTED: 80894
SUMMARY:
On certain vehicles, the Totally Integrated Power Module (TIPM) was programmed with software that may allow the engine to stall under certain operating conditions.
CONSEQUENCE:
This could cause a crash without warning.
REMEDY:
Dealers will reprogram the TIPM. The recall began on July 5, 2007. Owners may contact DaimlerChrysler at 1-800-853-1403.
NOTES:
DaimlerChrysler recall No. G25. Customers may also contact The National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to http://www.safercar.gov.
Dodge/Nitro 2007
Jeep/Wrangler 2007
MANUFACTURER: DaimlerChrysler Corporation
NHTSA CAMPAIGN ID NUMBER: 07V291000 MFR'S REPORT DATE: July 03, 2007
COMPONENT: Electrical System
POTENTIAL NUMBER OF UNITS AFFECTED: 80894
SUMMARY:
On certain vehicles, the Totally Integrated Power Module (TIPM) was programmed with software that may allow the engine to stall under certain operating conditions.
CONSEQUENCE:
This could cause a crash without warning.
REMEDY:
Dealers will reprogram the TIPM. The recall began on July 5, 2007. Owners may contact DaimlerChrysler at 1-800-853-1403.
NOTES:
DaimlerChrysler recall No. G25. Customers may also contact The National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to http://www.safercar.gov.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.