Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Wrangler V6-3.8LFACTORY OEM SERVICE PROCEDURE
Installation
INSTALLATION
NOTE: Typical A/C-heater control and center bezel shown.
1. Install the A/C-heater control (8) into the instrument panel center bezel (7).
2. Install the four screws (6) that secure the A/C-heater control to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Position the center bezel to the instrument panel and connect the wire harness connectors (3 and 4) to the back of the A/C-heater control.
NOTE: Install the mode control cable onto the A/C heater control first. Then install the temperature control cable.
4. Connect the control cables (1 and 9) to the mode door control sector gear (2) and the temperature control sector gear (5) and fully engaged the retaining clips. Make sure the retaining clips are fully engage to the sector gears.
5. Connect the control cables to the back of the A/C-heater control and fully engage the retaining clips. Make sure the retaining clips are fully engaged to the back of the A/C-heater control.
6. Connect the wire harness connectors to the switches and power outlets, as equipped and install the center bezel to the instrument panel.
7. Reconnect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.