Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Wrangler V6-3.8LFACTORY OEM SERVICE PROCEDURE
Sensor-Intrusion-Console
Component ID: 298
Component : SENSOR-INTRUSION-CONSOLE
Connector:
Name : SENSOR-INTRUSION-CONSOLE
Color : BLACK
# of pins : 3
Qualifier : (4 DOOR RHD)
Pin Description Circuit
1 FUSED B(+) (I.O.D.) A412 18RD
2 GROUND Z910 18BK/WT
2 LIN BUS D122 20WT/LG
3 LIN BUS D122 20WT/LG
3 GROUND Z910 18BK/WT
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.