Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Liberty Limited, RWDFACTORY OEM SERVICE PROCEDURE
Torque Chart
TORQUE SPECIFICATIONS
| DESCRIPTION | N-m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Camshaft Position Sensor - 3.7L | 12 | - | 106 |
| Crankshaft Position Sensor Nut/Bolt - 3.7L | 23 | 21 | 205 |
| * Knock Sensor Bolt - 3.7L | * 20 | * 15 +/- 2 | *176 |
| Ignition Coil Mounting Nuts - 3.7L | 8 | - | 70 |
| Ignition Coil Capacitor Nuts - 3.7L | 8 | - | 70 |
| Spark Plugs - 3.7L | 27 | 20 | - |
| * Do not apply any sealant, thread-locker or adhesive to bolts. Poor sensor performance may result. * Torque critical tapered design. Do not exceed 15 ft. lbs. |
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.