Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Liberty Limited, RWDFACTORY OEM SERVICE PROCEDURE
Glow Plug Module
| 1 - MASTER CYLINDER |
| 2 - GLOW PLUG MODULE |
| 3 - BATTERY |
CAUTION:
The glow plug system is a 7 volt system. DO NOT ATTEMPT to test the glow plug system with a 12V power source or damage will occur.
The glow plug module (2) is mounted to the inner fender between the battery and the master cylinder (1) in the engine compartment. For an explanation of the glow plug system operation. See OPERATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.