Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Tank Module
| 1 - LOCKRING |
| 2 - FUEL TANK MODULE |
| 3 - ELECTRICAL CONNECTOR |
| 4 - CHECK VALVE |
| 5 - FUEL VENT HOSE |
| 6 - FUEL FILL HOSE |
| 7 - FUEL RETURN LINE CONNECTION |
| 8 - FUEL SUPPLY LINE CONNECTION |
The fuel tank module (2) is installed in the top of the fuel tank. The fuel tank module contains the following components: See Fig 1.
- Fuel reservoir
- A separate in-tank fuel filter
- Fuel gauge sending unit (fuel level sensor)
- A special lockring (1) to retain module to fuel tank See Fig 1.
- Fuel supply line connections
- Fuel return line connections
A separate electric fuel pump (sometimes referred to as a low-pressure fuel transfer or lift pump) is not attached Β to the fuel tank module. Instead, a gear supply pump is mounted to the rear of the high-pressure fuel injection pump. This supply pump draws fuel under a vacuum; through the fuel filter; and from the fuel tank. Refer to Fuel Injection Pump for additional information.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
