2007 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE

Power Transfer Unit

WARNING: This page is about a different variant/trim than selected.
Fig 1: DRAIN AND FILL PLUGS
GC0056193Courtesy of CHRYSLER LLC
  1. If fluid level is low or fluid change is required fill with MOPAR® MS9020 SAE 80W90 Gear Lube until to bottom of fill plug.
  2. Tighten fill plug (1) to 32 N.m (24 ft. lbs.).
  3. Tighten drain plug (2) to 32 N.m (24 ft. lbs.).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.