2007 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE

Power Transfer Unit

WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS

DESCRIPTION  N.m  Ft. Lbs.  In. Lbs. 
Plug, Fill 32 24 -
Plug, Drain 32 24 -
Bolts, Inspection cover 23 17 -
Bolts, Vent Shield 23 17 -
Bolts, Vent 23 17 -
Bolts, Output Shaft Housing 38 28 -
Bolts, extension housing 38 28 -
Nut, Output Shaft 150 111 -
Bolts, Carrier Assembly Side Cover 23 17 -
Bolts, Ring Gear 74 55 -
Bolt and Nut, Rear Mount Through 75 55 -
Bolts, Transmission Crossmember 75 55 -
Bolt and Nut, Transmission Crossmember through 75 55 -
Bolts, PTU Mounting 58 43 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.