2007 Jeep Compass Limited, FWD, StandardFACTORY OEM SERVICE PROCEDURE

Power Transfer Unit

WARNING: This page is about a different variant/trim than selected.
Fig 1: REMOVE - INSTALL PTU
GC0056205Courtesy of CHRYSLER LLC
  1. Roll the PTU in, moving from front to back (1). See Fig 1.
    Fig 2: PTU INSTALL
    GC0056248Courtesy of CHRYSLER LLC
  2. Rest the PTU (1) on the frame (3) while the engine and transaxle (2) are raised back into position. See Fig 2.
    Fig 3: JACK AT TRANS MOUNT
    GC0056203Courtesy of CHRYSLER LLC
  3. Lower screw jack (2) until rear mount through bolt can be installed. See Fig 3.
    Fig 4: REAR ENGINE MOUNT
    GC0056201Courtesy of CHRYSLER LLC
  4. Install rear mount through bolt (2) and tighten bolt to 75 Nm (55 ft. lbs.). See Fig 4.
    Fig 5: FRONT ENGINE MOUNT
    GC0056249Courtesy of CHRYSLER LLC
  5. Install the transmission crossmember and bolts, (2) tighten to 75 Nm (55 ft. lbs.).
  6. Install the through bolt at the front transmission mount (1) and tighten to 75 Nm (55 ft. lbs.).
    Fig 6: PTU O-RING
    GC0056250Courtesy of CHRYSLER LLC
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.