2007 Jeep Compass Limited, AWD, StandardFACTORY OEM SERVICE PROCEDURE

Inputs and Outputs

Item - Shift Control Line Pressure Control Selection Control Lock-up Control CAN Communication Control Fail-safe Function (Note 1)
Input Engine speed signal - X X X X X
Accelerator pedal position signal X X X X X X
Closed throttle position signal X - - X X -
Stop lamp SW signal X X - X X X
Primary pressure sensor - X - - - -
Secondary pressure sensor - X X - - X
Fluid temperature sensor X X X X - X
Primary speed sensor X X - X - X
Secondary speed sensor X X x X - X
PNP switch X X X X - X
Output Line pressure solenoid value - X x - - X
Secondary pressure solenoid value - X X - - X
Lock-up solenoid value - - X X - X
Lock-up/Selection switching solenoid value - - X X - X
Stepping motor X - - - - X
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.