Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Compass 4WD L4-2.4L VIN WFACTORY OEM SERVICE PROCEDURE
Control Module: Locations
Component ID: 150
Component : MODULE-ALL WHEEL DRIVE CONTROL
Connector:
Name : MODULE-ALL WHEEL DRIVE CONTROL
Color :
# of pins : 16
Qualifier : (AWD)
Pin Description Circuit
1 - -
2 - -
3 - -
4 CAN C BUS (+) D65 20WT/BK
5 IGNITION SWITCH OUTPUT (RUN-START) F202 20PK/GY
6 FUSED B(+) A923 20RD/WT
7 - -
8 REAR DIFFERENTIAL SOLENOID CONTROL T312 20YL/VT
9 - -
10 - -
11 - -
12 CAN C BUS (-) D64 20WT/LB
13 - -
14 - -
15 GROUND Z967 20BK
16 SOLENOID SUPPLY VOLTAGE T78 20YL/BK
Component Location - 43
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
