Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Commander Overland, RWDFACTORY OEM SERVICE PROCEDURE
DTCS P1602 To P2123
- P1602-Pcm Not Programmed
- P1607-Pcm Internal Shutdown Timer Rationality Too Slow
- P1618-Sensor Reference Voltage 1 Circuit Erratic
- P1628-Sensor Reference Voltage 2 Circuit Erratic
- P1646-Hydraulic Cooling Fan Control Circuit Low
- P1647-Hydraulic Cooling Fan Control Circuit High
- P1696-EEPROM Memory Write Denied/Invalid
- P1697-EMR (Sri) Mileage Not Stored
- P1897-Level 1 Rpm Bus Unlock
- P2072-Electronic Throttle Control System - Ice Blockage
- P2074-Map/TPS Correlation - High Airflow/Vacuum Leak Detected
- P2096-Downstream Fuel Trim System 1 Lean
- P2097-Downstream Fuel Trim System 1 Rich
- P2098-Downstream Fuel Trim System 2 Lean
- P2099-Downstream Fuel Trim System 2 Rich
- P2100-Electronic Throttle Control Motor Circuit
- P2101-Electronic Throttle Control Motor Performance
- P2107-Electronic Throttle Control Module Processor
- P2110-Electronic Throttle Control - Forced Limited Rpm
- P2111-Electronic Throttle Control - Unable To Close
- P2112-Electronic Throttle Control - Unable To Open
- P2115-Accelerator Pedal Position Sensor 1 Minimum Stop Performance
- P2116-Accelerator Pedal Position Sensor 2 Minimum Stop Performance
- P2118-Electronic Throttle Control Motor Current Performance
- P2122-Accelerator Pedal Position Sensor 1 Circuit Low
- P2123-Accelerator Pedal Position Sensor 1 Circuit High
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.