2007 Jeep Commander Overland, 4WDFACTORY OEM SERVICE PROCEDURE

Starting System: Notes

The battery, starting, and charging systems operate in conjunction with one another, and must be tested as a complete system. For correct starting/charging system operation, all of the components involved in these three systems must perform within specifications.

STARTING SYSTEM DIAGNOSIS

Starting System Diagnosis
CONDITION POSSIBLE CAUSE CORRECTION
STARTER FAILS TO OPERATE. 1. Battery discharged or faulty. 1. Refer to BATTERY . Charge or replace battery, if required.
2. Starting circuit wiring faulty. 2. Refer to SYSTEM WIRING DIAGRAMS article. Test and repair starter feed and/or control circuits, if required.
3. Starter relay faulty. 3. The starter relay is located within the TIPM (Totally Integrated Power Module). Refer to "NO CRANK CONDITION ".
4. Ignition switch faulty. 4. Refer to IGNITION SWITCH and KEY LOCK CYLINDER . Replace ignition switch if required.
5. Park/Neutral position switch faulty or misadjusted. 5. Refer to Park/Neutral Position Switch (if equipped). Replace park/neutral position switch if required.
6. Starter solenoid faulty. 6. Refer to STARTER MOTORΒ . Replace starter motor assembly if required.
7. Starter motor faulty. 7. If all other starting system components and circuits test OK, replace starter motor.
STARTER ENGAGES, FAILS TO TURN ENGINE. 1. Battery discharged or faulty. 1. Refer to BATTERY . Charge or replace battery if required.
2. Starting circuit wiring faulty. 2. Refer to SYSTEM WIRING DIAGRAMS article. Test and repair starter feed and/or control circuits if required.
3. Starter motor faulty. 3. If all other starting system components and circuits test OK, replace starter motor assembly.
4. Engine seized. 4. Refer to DIAGNOSIS AND TESTING for 3.7L , DIAGNOSIS AND TESTING for 4.7L and DIAGNOSIS AND TESTING for 5.7L .
STARTER ENGAGES, SPINS OUT BEFORE ENGINE STARTS. 1. Starter ring gear faulty. 1. Refer to STARTER MOTORΒ  Removal and Installation. Remove starter motor to inspect starter ring gear. Replace starter ring gear if required.
2. Starter motor faulty. 2. If all other starting system components and circuits test OK, replace starter motor assembly.
STARTER DOES NOT DISENGAGE. 1. Starter motor improperly installed. 1. Refer to STARTER MOTORΒ  Removal and Installation. Tighten starter mounting hardware to correct torque specifications.
2. Starter relay faulty. 2. The starter relay is located within the TIPM (Totally Integrated Power Module). Refer to "NO CRANK CONDITION ".
3. Ignition switch faulty. 3. Refer to IGNITION SWITCH and KEY LOCK CYLINDER . Replace ignition switch if required.
4. Starter motor faulty. 4. If all other starting system components and circuits test OK, replace starter motor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.