Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE
System Specifications
General Description:
General Description
Cylinder Block:
Cylinder Block
Pistons:
Pistons
Piston Pins:
Piston Pins
Piston Rings:
Piston Rings
Connecting Rods:
Connecting Rods
Crankshaft:
Crankshaft
Vibration Damper-Bolt 176 Nm (129 ft. lbs.)
Connecting Rod Cap-Bolts 21 Nm plus 90� Turn (15 ft. lbs.) plus 90� Turn
Main Bearing Cap-Bolts M-12 27 Nm plus 90� Turn
Crossbolts M-8 28 Nm
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
