Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE
Sensor-Knock
Component ID: 474
Component : SENSOR-KNOCK
Connector:
Name : SENSOR-KNOCK
Color :
# of pins : 4
Qualifier : (4.7L)
Pin Description Circuit
1 KNOCK SENSOR NO. 1 RETURN K942 20BR/LG
2 KNOCK SENSOR NO. 1 SIGNAL K42 20DB/OR
3 KNOCK SENSOR NO. 2 RETURN K924 20PK/RD
4 KNOCK SENSOR NO. 2 SIGNAL K242 20BR/WT
Component Location - 20
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
