Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE
Control-A/C-Heater-Rear
Component ID: 75
Component : CONTROL-A/C-HEATER-REAR
Connector:
Name : CONTROL-A/C-HEATER-REAR C1
Color : NATURAL
# of pins : 8
Pin Description Circuit
1 FUSED RUN RELAY OUTPUT F850 20LB/PK
2 REAR BLEND DOOR CONTROL C54 20YL
3 REAR MODE DOOR CONTROL C53 20LG/BK
4 GROUND Z908 20BK
5 PANEL LAMPS DRIVER E2 20OR/BR
6 - -
7 - -
8 - -
Connector:
Name : CONTROL-A/C-HEATER-REAR C2
Color : NATURAL
# of pins : 6
Pin Description Circuit
1 REAR BLOWER HIGH SPEED C153 14DB/VT
2 REAR BLOWER MEDIUM SPEED C152 16LB
3 REAR BLOWER LOW SPEED C151 16DB/BR
4 GROUND Z908 14BK
5 - -
6 - -
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
