2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE

Switch-Power Liftgate-Rear




Component ID: 549
Component : SWITCH-POWER LIFTGATE-REAR

Connector:
Name : SWITCH-POWER LIFTGATE-REAR
Color :
# of pins : 4
Factory service manual diagram




Pin Description Circuit
1 LIFTGATE REAR SWITCH MUX G29 20OR/VT
2 - -
3 - -
4 LOGIC GROUND Q901 20OR/VT
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.