Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE
Navigation Module
Component ID: 209
Component : MODULE-TRAFFIC INFORMATION RECEIVER
Connector:
Name : MODULE-TRAFFIC INFORMATION RECEIVER C1
Color :
# of pins : 12
Pin Description Circuit
1 FUSED B+ (I.O.D.) A114 18GY/RD
2 - -
3 - -
4 - -
5 CAN B BUS (+) D55 20WT/OR
6 - -
7 - -
8 - -
9 - -
10 - -
11 CAN B BUS (-) D54 20WT
12 GROUND Z909 20BK
Connector:
Name : MODULE-TRAFFIC INFORMATION RECEIVER C2
Color :
# of pins : 2
Pin Description Circuit
1 AM/FM COAX D5 WT/OR
2 COAX SHIELD D931 WT/YL
Connector:
Name : MODULE-TRAFFIC INFORMATION RECEIVER C3
Color :
# of pins : 2
Pin Description Circuit
1 AM/FM COAX 2 D6
2 COAX SHIELD 2 D932 WT/YL
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
