Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE
Keyless Entry Module
Component ID: 206
Component : MODULE-SENTRY KEY REMOTE ENTRY/WCM
Connector:
Name : MODULE-SENTRY KEY REMOTE ENTRY/WCM
Color : BLACK
# of pins : 8
Pin Description Circuit
1 - -
2 COM-LIN TIRE PRESSURE MONITOR LAN D508 20WT/GY
3 FUSED IGNITION SWITCH OUTPUT (RUN-START) F941 20PK/LG
4 GROUND Z18 20BK/LB
5 FUSED B(+) A114 18GY/RD
6 CAN B BUS (+) D55 20WT/OR
7 CAN B BUS (-) D54 20WT
8 - -
Component Location - 40
Fig. 39:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
