2007 Jeep Commander 2WD V8-5.7L VIN 2FACTORY OEM SERVICE PROCEDURE

Keyless Entry Module: Locations




Component ID: 206
Component : MODULE-SENTRY KEY REMOTE ENTRY/WCM

Connector:
Name : MODULE-SENTRY KEY REMOTE ENTRY/WCM
Color : BLACK
# of pins : 8
Factory service manual diagram




Pin Description Circuit
1 - -
2 COM-LIN TIRE PRESSURE MONITOR LAN D508 20WT/GY
3 FUSED IGNITION SWITCH OUTPUT (RUN-START) F941 20PK/LG
4 GROUND Z18 20BK/LB
5 FUSED B(+) A114 18GY/RD
6 CAN B BUS (+) D55 20WT/OR
7 CAN B BUS (-) D54 20WT
8 - -

Component Location - 40

Fig. 39:

Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.