2006 Jeep Wrangler X, AutomaticFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Removal: 2.4L

The Camshaft Position Sensor (CMP) on the 2.4L 4-cylinder engine is bolted to the right-front side of the cylinder head. See Fig 1. Sensor position (depth) is adjustable.

  1. Disconnect electrical connector at CMP sensor.
  2. Remove 2 sensor mounting bolts.
  3. Remove sensor from cylinder head by sliding towards rear of engine.
Fig 1: CMP Location - 2.4L
GC0030867Courtesy of DAIMLERCHRYSLER CORP.
1 - CMP SENSOR
2 - ELECTRICAL CONNECTOR
3 - SLOTTED HOLES
4 - MOUNTING BOLTS (2)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.