Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Jeep Commander Base, 3.7 K, AWDFACTORY OEM SERVICE PROCEDURE
Power Locks DTCS
POWER LOCKS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| B1802 | DRIVER DOOR LOCK/UNLOCK SWITCH CIRCUIT HIGH - DRIVER DOOR MODULE |
| B1803 | DRIVER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK LOCK - DRIVER DOOR MODULE |
| B1804 | DRIVER DOOR MODULE DRIVER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK UNLOCK |
| B1807 | PASSENGER DOOR MODULE PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT HIGH |
| B1808 | PASSENGER DOOR MODULE PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK LOCK |
| B1809 | PASSENGER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK UNLOCK - PASSENGER DOOR MODULE |
| B182D | ALL DOOR LOCK CONTROL CIRCUIT LOW- CLUSTER |
| B182E | ALL DOOR LOCK CONTROL CIRCUIT HIGH- CLUSTER |
| B1835 | DRIVER DOOR UNLOCK CONTROL CIRCUIT LOW- CLUSTER |
| B1836 | DRIVER DOOR UNLOCK CONTROL CIRCUIT HIGH- CLUSTER |
| B1839 | PASSENGER DOORS UNLOCK CONTROL CIRCUIT LOW- CLUSTER |
| B183A | PASSENGER DOORS UNLOCK CONTROL CIRCUIT HIGH- CLUSTER |
| B184E | FLIPPER GLASS CONTROL CIRCUIT LOW- CLUSTER |
| B184F | FLIPPER GLASS CONTROL CIRCUIT HIGH- CLUSTER |
| B1851 | FLIPPER GLASS SWITCH STUCK- CLUSTER |
| B210D | BATTERY VOLTAGE LOW - DOOR MODULE |
| B210E | BATTERY VOLTAGE HIGH - DOOR MODULE |
| B2218 | DOOR MODULE INTERNAL - DOOR MODULE |
| B2219 | DOOR MODULE INTERNAL - DOOR MODULE |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
