2006 Jeep Commander Base, 3.7 K, AWDFACTORY OEM SERVICE PROCEDURE

Sensor-Intake Air Temperature: Removal: 4.7L

Fig 1: IAT Sensor Tab/O-Ring - 3.7L/4.7L/5.7L
GC0006585Courtesy of DAIMLERCHRYSLER CORP.
1 - IAT SENSOR
2 - SENSOR O-RING
3 - RELEASE TAB

The intake manifold air temperature (IAT) sensor) is installed into the air inlet tube.

  1. Disconnect electrical connector from IAT sensor.
  2. Clean dirt from air inlet tube at sensor base.
  3. Gently lift on small plastic release tab (3). See Figure and rotate sensor about 1/4 turn counter-clockwise for removal.
  4. Check condition of sensor O-ring (2).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.