2006 Jeep Commander Base, 3.7 K, AWDFACTORY OEM SERVICE PROCEDURE

Module-Integrated Power: Removal

Fig 1: Removing/Installing IPM
GC0029596Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the Integrated Power Module (IPM) cover by pulling up on the cover tabs (7) and pivoting the cover outward.
    Fig 2: Removing/Installing Battery Positive Cable
    GC0029597Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the nut (2) from the IPM B+ terminal stud.
  4. Remove the battery positive cable (3) from the IPM B+ terminal stud.
    Fig 3: Removing/Installing IPM
    GC0029596Courtesy of DAIMLERCHRYSLER CORP.
  5. Using a suitable flat bladed tool, depress the three retaining clips and lift the IPM (1) straight up off of the bracket tabs (2).
  6. Disconnect the two IPM connectors (4).
  7. Disconnect the two Front Control Module (FCM) connectors (5).
  8. Remove the IPM assembly from the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.