2006 Jeep Commander Base, 3.7 K, AWDFACTORY OEM SERVICE PROCEDURE

Charging System: Generator: Installation: 5.7L

Fig 1: Removing/Installing Generator - 5.7L
GC0008576Courtesy of DAIMLERCHRYSLER CORP.
  1. Position generator (2) to engine and install 2 mounting bolts (1).
  2. Torque bolts to 30 ft. lbs. (41 N.m).
  3. Snap field wire connector (3) into rear of generator.
  4. Install B+ terminal eyelet to generator output stud. Tighten mounting nut to 108 in. lbs. (12 N.m).
    CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.