Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Jeep TJ (CANADA) L6-4.0LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
CONNECTING RODS
Connecting Rod Nuts 45 Nm (33 ft. lbs.)
Bearing Clearance 0.025 - 0.076 mm (0.001 - 0.003 inch)
Preferred 0.044 - 0.050 mm (0.0015 - 0.0020 inch)
Side Clearance 0.25 - 0.48 mm (0.010 - 0.019 inch)
Piston Pin Bore Diameter 0.023.59 - 23.62 mm (0.9288 - 0.9298 inch)
Bearing Bore (Less Bearings) 56.08 - 56.09 mm (2.2080 - 2.2085 inch)
Total Weight (Less Bearing) 663-671 Grams (23.39 - 23.67 oz.)
Length (Center To Center) 155.52 - 155.62 mm (6.123 - 6.127 inch)
Twist (MAX.) 0.002 mm (per mm (0.002 inch) per inch
Bend (MAX.) 0.002 mm (per mm (0.002 inch) per inch
Connecting Rod Nuts 45 Nm (33 ft. lbs.)
Bearing Clearance 0.025 - 0.076 mm (0.001 - 0.003 inch)
Preferred 0.044 - 0.050 mm (0.0015 - 0.0020 inch)
Side Clearance 0.25 - 0.48 mm (0.010 - 0.019 inch)
Piston Pin Bore Diameter 0.023.59 - 23.62 mm (0.9288 - 0.9298 inch)
Bearing Bore (Less Bearings) 56.08 - 56.09 mm (2.2080 - 2.2085 inch)
Total Weight (Less Bearing) 663-671 Grams (23.39 - 23.67 oz.)
Length (Center To Center) 155.52 - 155.62 mm (6.123 - 6.127 inch)
Twist (MAX.) 0.002 mm (per mm (0.002 inch) per inch
Bend (MAX.) 0.002 mm (per mm (0.002 inch) per inch
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
