Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Jeep TJ (CANADA) L4-2.4LFACTORY OEM SERVICE PROCEDURE
System Specifications
FRONT AXLE ± 1 oz. (0.03 L)
181 FBI (Model 30) 2.5 pts. (1.2 L)
216 RBI (Model 44) 4.0 pts. (1.89 L)
REAR AXLE ± 1 oz. (0.03 L)
194 RBI (Model 35) 3.5 pts. (1.66 L)
216 RBI (Model 44) 4.0 pts. (1.89 L)
Note: With Trac-lok add 4.0 oz. (118 ml) of Limited Slip Additive.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.