2004 Jeep Wrangler X, StandardFACTORY OEM SERVICE PROCEDURE

Throttle Control Cable: Installation: 2.4L

  1. Slide accelerator cable plastic mount into throttle body mounting bracket. Continue sliding until release tab is aligned to hole in mounting bracket.
  2. Hold throttle in wide open position. While held in this position, slide throttle cable pin into throttle body bellcrank.
  3. Push cable housing into rubber grommet and through opening in dash panel.
  4. Push other end of cable through opening in dash panel until retaining tabs lock into panel.
  5. From inside vehicle, slide throttle cable core wire into opening (slot) in top of pedal arm.
  6. Push plastic cable retainer (clip) into pedal arm opening until it snaps in place.
  7. Install air box to throttle body.
  8. Before starting engine, operate accelerator pedal to check for any binding.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.