2004 Jeep Wrangler X, AutomaticFACTORY OEM SERVICE PROCEDURE

4.0L Early

An L-shaped rubber fitting is used to connect the MAP sensor to throttle body.

Fig 1: Identifying 4.0L MAP Sensor Mounting - Early
G01740976Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove air cleaner intake tube at throttle body.
  2. Remove two MAP sensor mounting bolts (screws).
  3. While removing MAP sensor, slide the rubber L-shaped fitting from throttle body.
  4. Remove rubber L-shaped fitting from MAP sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.