2004 Jeep Wrangler SE, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Control Cable: Removal: 2.4L

CAUTION: Be careful not to damage or kink the cable core wire (within the cable sheathing) while servicing accelerator pedal or throttle cable.
  1. From inside vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) and throttle cable core wire from upper end of pedal arm. Plastic cable retainer snaps into top of pedal arm.
    Fig 1: Identifying Accelerator Pedal Mounting
    G01740983Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove cable core wire at pedal arm.
  3. From inside vehicle, pinch both sides of cable housing retainer tabs at dash panel. Remove cable housing from dash panel and pull into engine compartment.
  4. Remove air box at throttle body.
  5. Unsnap cable from dashpanel routing clip.
  6. Remove cable housing from dash panel and pull into engine compartment.
  7. Hold throttle in wide open position. While held in this position, slide throttle cable pin from throttle body bellcrank.
    Fig 2: Locating Throttle Cable, Pin & Release Tab - 2.4L
    G01740984Courtesy of DAIMLERCHRYSLER CORP.
  8. Using a pick or small screwdriver, press release tab to release plastic cable mount from bracket. Press on tab only enough to release cable from bracket. If tab is pressed too much, it will be broken.Β  To remove throttle cable from throttle body bracket, slide cable towards front of vehicle.
  9. Remove throttle cable from vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.