Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
PCV Valve: Removal: 2.4L
The PCV valve is attached to the left/front side of the valve cover. See Figure. It is secured with 1 bolt. An o-ring is used to seal valve to valve cover. See Figure. Another type of threaded PCV valve may be used. See Figure.
- Remove hose from valve. Check condition of hose.
- Bolted PCV Valve:
- Remove 1 bolt.
- Remove PCV valve from valve cover.
- Check condition of valve o-ring.
- Threaded PCV Valve:
- Unscrew valve from valve cover.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.