2002 Jeep Wrangler X, AutomaticFACTORY OEM SERVICE PROCEDURE

Grand Cherokee (4.7L)

  1. Turn ignition off. Ensure throttle plate and linkage are not binding. Repair throttle plate and linkage as necessary before continuing. If throttle plate and linkage are okay, go to next step.
  2. Start engine and allow it to idle. Check engine, brake booster and vacuum hoses for leaks. Ensure Positive Crankcase Ventilation (PCV) system is functioning properly. Repair vacuum leaks as necessary. If PCV system is okay and no vacuum leaks exist, go to next step.
  3. Turn ignition off. Disconnect vacuum hose from PCV valve. Install Miller Fixed Orifice Adapter (6714) into disconnected vacuum hose in place of PCV valve. Fixed orifice adapter is a .185" air metering orifice. See Figure . Disconnect purge hose from throttle body fitting and cap fitting. Purge hose is located on front of throttle body next to Manifold Absolute Pressure (MAP) sensor. Start engine and allow it to idle. Ensure all accessories are off. Allow engine to reach normal operating temperature. Using scan tool, actuate MIN AIRFLOW. If engine speed is 500-900 RPM, no problem is indicated at this time. Test is complete. If engine speed is not 500-900 RPM, go to next step.
  4. Turn ignition off. Remove throttle body. While holding throttle open, spray entire throttle body bore with appropriate cleaner. Using a soft scuff pad, clean throttle body bore and throttle plate. Using compressed air, dry throttle body. Install throttle body. Ensure PCV adapter is still installed and throttle body fitting is capped. Start engine and allow it to idle. Ensure engine is at normal operating temperature. Using scan tool, actuate MIN AIRFLOW. If engine speed is not 500-900 RPM, replace throttle body. If engine speed is 500-900 RPM, no problem is indicated at this time. Test is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.