Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Jeep TJ (CANADA) L4-2.5LFACTORY OEM SERVICE PROCEDURE
Power Distribution Center Support Bracket Replacement
Power Distribution Center Support Bracket Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the Power Distribution Center (PDC) from the PDC bracket (Refer to POWER DISTRIBUTION/POWER DISTRIBUTION CENTER - REMOVAL).
3. Remove the three screws that secure the PDC bracket to the right front inner fender (Fig. 15).
4. Remove the PDC bracket from the right front inner fender.
INSTALLATION
1. Position the PDC bracket onto the right front inner fender.
2. Install and tighten the three screws that secure the PDC mounting bracket to the right front inner fender. Tighten the screws to 3.9 Nm (35 in. lbs.).
3. Install the PDC onto the PDC bracket (Refer to POWER DISTRIBUTION/POWER DISTRIBUTION CENTER - INSTALLATION).
4. Reconnect the battery negative cable.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the Power Distribution Center (PDC) from the PDC bracket (Refer to POWER DISTRIBUTION/POWER DISTRIBUTION CENTER - REMOVAL).
Fig.15 PDC Bracket:
3. Remove the three screws that secure the PDC bracket to the right front inner fender (Fig. 15).
4. Remove the PDC bracket from the right front inner fender.
INSTALLATION
1. Position the PDC bracket onto the right front inner fender.
2. Install and tighten the three screws that secure the PDC mounting bracket to the right front inner fender. Tighten the screws to 3.9 Nm (35 in. lbs.).
3. Install the PDC onto the PDC bracket (Refer to POWER DISTRIBUTION/POWER DISTRIBUTION CENTER - INSTALLATION).
4. Reconnect the battery negative cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.