2002 Jeep Liberty Limited, RWDFACTORY OEM SERVICE PROCEDURE

Transmission Verification Test

  1. Connect the DRBIII(R) to the Data Link Connector.
  2. Reconnect any disconnected components.
  3. With the DRBIII(R), erase DTC's.
  4. With the DRBIII(R), display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT above 110°F (43°C).
  5. Check the Transmission fluid and adjust if necessary.
  6. If the TCM has been replaced or if the transmission has been repaired or replaced it is necessary to perform the DRBIII(R) Quick Learn Procedure.
  7. Road test the vehicle. With the DRBIII(R), monitor TPS. Make fifteen to twenty 1-2, 2-3, and 3-4 upshifts.
  8. Perform these shifts from a standing start to 60 MPH (97 Km/h) with a constant throttle opening of 20 to 25 degrees.
  9. Below 25 MPH (40 Km/h), make five to eight wide open throttle kickdowns to 1st gear. Allow at least 5 seconds each in 2nd and 3rd gear between each kickdown.
  10. Check for DTC's during the road test.
  11. Use the EATX OBDII task manager to run Good Trip time in each gear, this will confirm the repair and to ensure that the DTC has not re-matured. Were any Trouble Codes set during the road test? If yes, refer to SYMPTOM IDENTIFICATION  table for the related symptom(s). If no, repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.