2002 Jeep Liberty Limited, RWDFACTORY OEM SERVICE PROCEDURE

Powertrain Verification Test VER-2

  1. Inspect the vehicle to ensure that all engine components are properly installed and connected. Reassemble and reconnect components as necessary.
  2. If this verification procedure is being performed after a NO TROUBLE CODE repair, perform Steps  3 and  4 .
  3. Check to see if the initial symptom still exists. If there are DTC's or the symptom no longer exists, the repair was successful and testing is complete.
  4. If the initial or another symptom exists, the repair is not complete. Check all technical service bulletins or flash updates and refer to SYMPTOM IDENTIFICATION  table for the related symptom(s) if necessary.
  5. If this verification procedure is being performed after a DTC repair, perform steps  6 -  13 .
  6. Connect the DRBIII(R) to the data link connector. With the DRBIII(R), erase DTCs and reset all values.
  7. If the PCM was not replaced, skip steps  8 -  10 and continue with the verification.
  8. If the PCM was replaced, the correct VIN and mileage must be programmed or a DTC will set in the ABS and Air Bag modules. In addition, if the vehicle is equipped with Sentry Key Immobilizer System (SKIS), Secret Key data must be updated to enable start.
  9. For ABS and Air Bag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS and Air Bag modules.
  10. For SKIS theft alarm, connect DRBIII(R) to data link connector. Go to Theft Alarm, SKIM, and Misc. Place SKIM in secured access mode by using the appropriate PIN code for this vehicle. Select Update the Secret Key data. Data will be transferred from SKIM to PCM
  11. If equipped with a Transfer Case Position Switch, Perform next step, otherwise, continue with step  13 .
  12. With the ignition switch on, place the Transfer Case Shift Lever in each gear position, stopping for 15 seconds in each position.
  13. Road test the vehicle. If the test is for an A/C DTC, ensure it is operating during the following test.
  14. Drive the vehicle for at least 5 minutes at 40 mph (64 Km/h). Ensure the transmission shifts properly through all gears. At some point stop the vehicle and turn off the engine for at least 10 seconds.
  15. With the DRBIII(R), read DTC's. Are any DTCs or symptoms remaining? If yes, check for any related Technical Service Bulletins and/or refer to SYMPTOM IDENTIFICATION  table for the related symptom(s). If no, repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.