Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Jeep Liberty Limited, RWDFACTORY OEM SERVICE PROCEDURE
Low Wash Message Not Operating Properly
Possible Causes:
- Washer Fluid Level Switch Always Closed
- Low Washer Fluid Sense Circuit Short To Ground
- Low Washer Fluid Sense Circuit Short To Ground
- Washer Fluid Level Switch Always Open
- Washer Fluid Level Switch Ground Circuit Open
- Instrument Cluster
Testing
- Turn the ignition on and wait approximately one minute. Is the LOWASH message always displayed? If yes, go to next step. If no, go to step 3 .
- Turn the ignition off. Disconnect the Washer Fluid Level Switch harness connector. Turn the ignition on and wait approximately one minute. Does the VF display LOWASH? If yes, repair the Low Washer Fluid Sense circuit for a short to ground. Perform BODY VERIFICATION TEST . If no, replace the Washer Fluid Level Switch. See WASHER FLUID LEVEL SWITCH under REMOVAL & INSTALLATION in WIPER/WASHER SYSTEMS - LIBERTY article. Perform BODY VERIFICATION TEST .
- Turn the ignition off. Disconnect the Washer Fluid Level Switch harness connector. Connect a jumper wire between cavity 1 and cavity 2. Turn the ignition on and wait approximately one minute. Does the VF display LOWASH? If yes, replace the Washer Fluid Level Switch. See WASHER FLUID LEVEL SWITCH under REMOVAL & INSTALLATION in WIPER/WASHER SYSTEMS - LIBERTY article. Perform BODY VERIFICATION TEST . If no, go to next step.
- Turn the ignition off. Disconnect the Washer Fluid Level Switch harness connector. Measure the resistance between ground and the Washer Fluid Level Switch Ground circuit. Is the resistance below 5.0 ohms? If yes, go to next step. If no, repair the Washer Fluid Level Switch Ground circuit for an open. Perform BODY VERIFICATION TEST .
- Turn the ignition off. Disconnect the Washer Fluid Level Switch harness connector. Disconnect the Instrument Cluster harness connector. Measure the resistance of the Low Washer Fluid Sense circuit. Is the resistance below 5.0 ohms? If yes, replace the Instrument Cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in ANALOG INSTRUMENT PANELS - LIBERTY article. Perform BODY VERIFICATION TEST . If no, repair the Low Washer Fluid Sense circuit for an open. Perform BODY VERIFICATION TEST .
NOTE:
Ensure that the Washer Fluid reservoir is filled and the Fluid Level Switch connector is properly connected before proceeding with this test.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.