Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Jeep Liberty Limited, RWDFACTORY OEM SERVICE PROCEDURE
No PCM Messages Received
Possible Causes:
- DTC Present
- No Response PCI Bus PCM
- Compass Mini-Trip Computer
Testing
- With the DRBIII(R), erase DTCs. Cycle the ignition and wait approximately one minute. With the DRBIII(R), read DTCs. Did this DTC reset? If yes, go to next step. If no, the condition is not present at this time. Monitor DRBIII(R) parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins (TSB) that may apply. Visually inspect the related wiring harness and connector terminals.
- Turn the ignition on. With the DRBIII(R), enter Body Computer, System Tests, then PCM Monitor. Does the DRBIII(R) display PCM Active on the Bus? If yes, replace the Compass Mini-Trip Computer. See OVERHEAD CONSOLES - LIBERTY for REMOVAL & INSTALLATION. Perform BODY VERIFICATION TESTΒ . If no, refer to COMMUNICATION in DIAGNOSTIC TROUBLE CODE IDENTIFICATIONΒ or SYMPTOM IDENTIFICATIONΒ tables for the related symptom(s).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
