2002 Jeep Grand Cherokee OverlandFACTORY OEM SERVICE PROCEDURE

Front Wheel Speed Sensor: Installation

  1. Install the sensor on the steering knuckle.
  2. Apply Mopar Lock N' Seal or Loctite(R) 242 to the sensor mounting bolt. Use new sensor bolt if original bolt is worn or damaged.
  3. Install the sensor mounting bolt and tighten bolt to 12-14 N.m (106-124 in. lbs.).
  4. Engage the grommets on the sensor wire to the steering knuckle brackets.
  5. Connect the sensor wire to the harness connector.
  6. Check the sensor wire routing. Be sure the wire is clear of all chassis components and is not twisted or kinked at any spot.
  7. Remove the support and lower vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.