Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Jeep Grand Cherokee OverlandFACTORY OEM SERVICE PROCEDURE
Road Test Verification
- Inspect the vehicle to ensure that all engine components are properly installed and connected. Reassemble and reconnect components as necessary.
- If this verification procedure is being performed after a non-DTC test, perform steps 3 and 4 .
- Check to see if the initial symptom still exists. If there are no trouble codes and the symptom no longer exists, the repair was successful and testing is now complete.
- If the initial or another symptom exists, the repair is not complete. Check all pertinent Technical Service Bulletins (TSBs) and return to the Symptom List if necessary
- For previously read DTCs that have not been dealt with, return to the Symptom List and follow the diagnostic path for that DTC; otherwise, continue.
- If the Engine Control Module (ECM) has not been changed, perform steps 7 and 8 . If the Engine Control Module (ECM) has been changed, go to step 9 .
- Using the DRBIII(R), erase all diagnostic trouble codes (DTCs), then disconnect the DRBIII(R).
- Turn ignition off for at least 10 seconds.
- If equipped with a Transfer Case Position Switch, perform step 10 , otherwise, continue with step 11 .
- With the ignition switch on, place the Transfer Case Shift Lever in each gear position, stopping for 15 seconds in each position.
- Ensure no DTCs remain by performing steps 12 through 15 .
- Road test the vehicle. For some of the road test, go at least 40 MPH (64 KMH). If this test is for an A/C Relay Control Circuit, drive the vehicle for at least 5 minutes with the A/C on.
- At some point, stop the vehicle and turn the engine off for at least 10 seconds, then restart the engine and continue.
- Upon completion of the road test, turn the engine off and check for DTCs with the DRBIII(R).
- If the repaired DTC has reset, the repair is not complete. Check for any pertinent Technical Service Bulletins (TSBs) and return to the Symptom. If there are no DTCs, the repair was successful and is now complete. Are any DTCs or symptoms remaining? If yes, repair is not complete. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION or SYMPTOM IDENTIFICATION tables under RETRIEVING & CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. If no, repair is complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
