Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ambient Temperature Sensor Fault Codes: Notes
The outside temperature function is supported by the Ambient Temperature Sensor (ATS), a signal and ground circuit hardwired to the BCM, and the EVIC display. If the EVIC display indicates 54°C (130°F) or the ATS sense circuit is shorted to ground, the temp display will be 54°C (130°F) to indicate a SHORT circuit condition. If the EVIC display indicates -40°C (-40°F) or the ATS sense circuit is open, the temp display will be -40°C (-40°F) to indicate an OPEN circuit condition. If there is an OPEN or SHORT circuit condition, it must be repaired before the EVIC VFD can be tested.
The ATS is supported by the BCM. Ambient Temperature Sensor DTCs will be recorded in the BCM. The ATS can be diagnosed using the AMBIENT TEMPERATURE SENSOR TEST . Test the ATS circuits using appropriate test in DIAGNOSTIC TESTS or SYMPTOM TESTS. If the EVIC passes the self test, and the ATS, the circuits, and PCI bus communications are confirmed to be OK, but the EVIC temperature display is inoperative or incorrect, replace the BCM.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
