2001 Jeep TJ (CANADA) L6-4.0LFACTORY OEM SERVICE PROCEDURE

Engine Mount

Engine Mount Front Support Bracket Bolt 45 Foot Pound-Force (ft.lb)
Support Bracket Cushion Bolt/nut 30 Foot Pound-Force (ft.lb)
Support Bracket Cushion Bolt 40 Foot Pound-Force (ft.lb)
Support Bracket Cushion Stud Nut 30 Foot Pound-Force (ft.lb)
Support Cushion Thru-Bolt 48 Foot Pound-Force (ft.lb)
Engine Rear Mount Crossmember to Sill Bolt (Automatic) 30 Foot Pound-Force (ft.lb)
Insulator Stud Assembly - Nut 30 Foot Pound-Force (ft.lb)
Support Cushion/Crossmember - Nuts 192 Inch Pound-Force (in.lb)
Support Cushion/Bracket-Nut (Manual) 55 Foot Pound-Force (ft.lb)
Transmission Support Bracket Manual 34 Foot Pound-Force (ft.lb)
Transmission Support Bracket Cushion - Bolt (4WD) 55 Foot Pound-Force (ft.lb)
Transmission Support Bracket Cushion - Bolt (2WD) 55 Foot Pound-Force (ft.lb)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.