2001 Jeep Cherokee Limited, RWDFACTORY OEM SERVICE PROCEDURE

Starter Relay Test: Cherokee

NOTE: Perform SOLENOID CIRCUIT TESTΒ  under ON-VEHICLE TESTING before testing starter relay.
  1. Remove starter relay from Power Distribution Center (PDC). PDC is located in engine compartment. Refer to PDC label for starter relay identification. Using DVOM, check for continuity between starter relay terminals C9 and C10. See Figure. If no continuity exists, replace starter relay. If no continuity exists, go to next step.
  2. Using DVOM, measure resistance between starter relay terminals C6 and C8. If resistance is not 70-80 ohms, replace starter relay. If resistance is 70-80 ohms, connect a 12-volt power source to starter relay terminals C6 and C8. Continuity should exist between starter relay terminals C9 and C10. Replace starter relay if it does not test as specified. If starter relay tests as specified, go to STARTER RELAY CIRCUIT TESTΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.