2001 Jeep Cherokee Classic, RWDFACTORY OEM SERVICE PROCEDURE

DTC P0131: 1/1 O2 Sensor Shorted To Ground: Description

1/1 Heated Oxygen Sensor (HO2S) voltage is monitored after ignition is turned off and 1/1 HO2S cools down, and after the next time ignition is turned on, provided engine coolant temperature is less than 98°F (37°C) and ambient/battery temperature is within plus or minus 27°F (-3°C) of engine coolant temperature. DTC will set in Powertrain Control Module (PCM) memory when PCM senses 1/1 HO2S voltage is less than 0.16 volt for 28 seconds after engine is started. Possible causes for DTC to set are: defective 1/1 HO2S, or defective connectors or wiring.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.