Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Instrument Cluster
Instrument cluster includes a speedometer, tachometer, fuel gauge, oil pressure gauge, water temperature gauge, voltmeter and a series of warning lights.
Powertrain Control Module (PCM) sends signals necessary for instrument cluster to position gauges. Instrument cluster receives these messages from Chrysler Collision Detection (CCD) bus and translates them into gauge positions. Body Control Module (BCM) sends status of some indicator lights and dimming level to instrument cluster over CCD bus when ignition switch is in ON or START positions. Other indicator lights are hard-wired directly to system being monitored. Malfunction Indicator Light (MIL) status is sent to BCM from PCM over CCD bus. All other instrument cluster features only work when ignition switch is in ON position. Vehicle chime function and rear window defogger timer are part of instrument cluster circuit board.
Vacuum Florescent (VF) odometer/trip display works when ignition switch is in ON or START positions. BCM stores mileage information for odometer display. If CCD bus is not functioning, odometer will display dashes instead of mileage. BCM sends mileage message and dimming level message to vacuum fluorescent display when ignition switch is in ON position. PCM Diagnostic Trouble Codes (DTC) can be accessed using VF display by turning ignition switch from OFF to ON position 3 times.
Instrument cluster indicator lights controlled by CCD bus are as follows.
- Air Bag
- Cruise Control
- Low Fuel Warning
- Low Washer Fluid
- Upshift (M/T Only)
- Seat Belt
- Sentry Key Immobilizer
- Engine Temperature
- Battery Charge (If Equipped)
- Low Oil Pressure Warning (If Equipped)
- Check Gauges
Instrument cluster indicator lights hard-wired to monitored system are as follow:
- Brake
- Full Time 4WD
- Part Time 4WD
- High Beam
- Left Turn Signal
- Right Turn Signal
- Liftgate Ajar
- ABS (Amber Light)
- Malfunction Indicator Light (MIL)
- SKIM
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
