Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Jeep TJ (CANADA) L6-4.0LFACTORY OEM SERVICE PROCEDURE
Service Specifications
| Gear to Body Clearance | Radial | 0.002 - 0.006 |
| Radial Preferred | 0.002 | |
| Gear end Clearance | Plastigage | 0.002 - 0.006 |
| Plastigage preferred | 0.002 | |
| Feeler Gauge | 0.004 - 0.008 | |
| Feeler Gauge Preferred | 0.007 | |
| Oil Pressure | Min. | 13 at 600 |
| Min. at Higher RPM | 37 - 75 at 1600 | |
| Relief | 75 | |
| Oil Pump | Mounting Bolts | 204 |
| Cover Bolts | 70 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.