Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Jeep TJ (CANADA) L4-2.5LFACTORY OEM SERVICE PROCEDURE
Window Track: Service and Repair
GLASS RUN CHANNEL
REMOVAL
1. Lower the window.
2. Using a trim stick C-4755 or equivalent, carefully pry the glass run channel weatherstrip from the window opening frame.
3. Remove the door glass.

4. Grasp the glass run channel weatherstrip in the door (Fig. 8) and pull from the channel.
INSTALLATION
NOTE: Applying a small amount of lubricant to the weatherstrip may ease the installation.
1. Position the weatherstrip in the lower door channels and press into place.
2. Install the door glass.
3. Position the weatherstrip in the window opening frame and press into place.
NOTE: Ensure that the glass is seated properly. Improperly seated door glass will result in high glass roll-up/roll-down effort.
REMOVAL
1. Lower the window.
2. Using a trim stick C-4755 or equivalent, carefully pry the glass run channel weatherstrip from the window opening frame.
3. Remove the door glass.
Fig. 8:
4. Grasp the glass run channel weatherstrip in the door (Fig. 8) and pull from the channel.
INSTALLATION
NOTE: Applying a small amount of lubricant to the weatherstrip may ease the installation.
1. Position the weatherstrip in the lower door channels and press into place.
2. Install the door glass.
3. Position the weatherstrip in the window opening frame and press into place.
NOTE: Ensure that the glass is seated properly. Improperly seated door glass will result in high glass roll-up/roll-down effort.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
