Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Jeep TJ (CANADA) L4-2.5LFACTORY OEM SERVICE PROCEDURE
Engine Mount
| Engine Front Insulator Bracket | Bolts | 60 Foot Pound-Force (ft.lb) |
| Insulstor Braket | Nuts | 35 Foot Pound-Force (ft.lb) |
| Through Bolt | 60 Foot Pound-Force (ft.lb) | |
| Engine Rear Support Cushion | Crossmember- Nuts | 192 Inch Pound-Force (in.lb) |
| Bracket-Nuts | 34 Foot Pound-Force (ft.lb) | |
| Transmission Support Bracket | Bolts | 32 Foot Pound-Force (ft.lb) |
| Cushion bolt | 55 Foot Pound-Force (ft.lb) | |
| Adapter- Bolt | 55 Foot Pound-Force (ft.lb) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.