Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Jeep Cherokee Limited, 2D PickupFACTORY OEM SERVICE PROCEDURE
Control Circuit Tests
Control circuit components should be tested in the following order:
- Starter relay. See STARTER RELAY TEST under BENCH TESTING.
- Starter solenoid. See SOLENOID TEST under BENCH TESTING.
- Ignition switch. See IGNITION SWITCH TEST .
- On manual transmission equipped models, Clutch Pedal Position (CPP) switch. See CLUTCH PEDAL POSITION SWITCH .
- On automatic transmission equipped models, Park/Neutral Position (PNP) switch or Transmission Range (TR) sensor. See PARK/NEUTRAL POSITION SWITCH or TRANSMISSION RANGE (TR) SENSOR .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.