Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Jeep Cherokee Limited, 2D PickupFACTORY OEM SERVICE PROCEDURE
Front Power Window Switch
- Front power window switch is integral to front door module. Remove suspect door module. See DOOR MODULE under REMOVAL & INSTALLATION.
- With switch in specified position, check switch continuity. Continuity should exist between terminals being tested. See DRIVER DOOR MODULE POWER WINDOW SWITCH CONTINUITY or PASSENGER DOOR MODULE POWER WINDOW SWITCH CONTINUITY table. See Figure and Figure .
- If continuity is as specified, go to POWER WINDOW MOTOR . If continuity check is not as specified, replace faulty door module.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
